Sludge Dewatering Screw Presses in Burnaby, British Columbia

A sludge dewatering screw press turns at one to two revolutions per minute. That single number explains most of why plants choose it. Slow rotation means low wear, low energy draw, almost no noise, and a machine that runs 24/7 unattended while producing a stackable cake at 18 to 30 percent dry solids from municipal and industrial biosolids.

A patient mechanism

The mechanism is patient rather than violent. A slowly turning screw conveys conditioned sludge through a cylindrical screen basket while the flight pitch tightens and the shaft diameter grows, squeezing free water out through the screen as the sludge travels. Filtrate drains continuously, cake discharges against an adjustable pressure cone, and the whole process happens inside a fully enclosed body, so there are no aerosols and no odour escaping into the building. For operators, that enclosure is often the deciding argument after years with an open belt press: no spray, no washdown shift, and washwater consumption that is a small fraction of what a belt machine drinks.

Polymer dosing that tracks the sludge

Polymer conditioning still matters, and our packages integrate automatic polymer dosing that tracks feed rate, so the chemistry follows the sludge instead of being set once and forgotten. Turndown is wide; the same machine handles the Monday surge and the Sunday trickle without operator intervention, which is exactly what a small municipal plant or a food processor without a dedicated dewatering operator needs. Maintenance is measured in years rather than months because at these speeds there is very little to wear out.

Where the alternatives fit

The alternatives each have their place, and we sell those too. A centrifuge beats a screw press on cake dryness when every point of dry solids counts against hauling fees. A belt press wins on very high throughput. The screw press wins on total cost of ownership for small and mid-sized plants: lowest energy per tonne, least operator attention, quietest installation and simplest cleaning. The 140 monthly Canadian searches for this machine come disproportionately from plants replacing exactly those older technologies.

Sizing inputs

Sizing is driven by sludge type, feed solids concentration and throughput, so send us your sludge source, your current volumes and a recent analysis if you have one. We return a sized configuration, budget price and delivery timeline for your facility, anywhere in Canada, and every proposal crosses a process engineer's desk before it crosses yours. Pilot and rental arrangements can be made where the sludge is unusual enough to warrant proof first. Screen baskets and screw flights are supplied as replacement parts with known lead times, and the enclosed body opens for inspection without special tooling, which keeps the maintenance you rarely need simple when it finally comes due.