Power, Boilers & Cooling Towers in Edmonton, Alberta

Boilers and cooling towers are the two places where a plant's water problems become energy problems. A millimetre of scale on a boiler tube forces the burner to work measurably harder for the same steam. A fouled cooling tower approaches its design temperature limit on the hottest week of the year, exactly when production can least afford it. Boiler and cooling tower water treatment is therefore less about meeting a discharge permit than about protecting the equipment the water passes through, though the blowdown from both systems still has to go somewhere legal.

The boiler side

On the boiler side, the goal is feedwater that will not scale, corrode or carry over into the steam. Softening removes hardness; an industrial reverse osmosis system ahead of the softener or in place of it takes out the dissolved solids load wholesale, which cuts chemical consumption and lets the boiler run more cycles of concentration before blowdown. Higher cycles mean less blowdown, and less blowdown means less fuel heating water that goes straight to the drain. For high-pressure boilers, RO followed by demineralization or electrodeionization is the standard train. The payback arithmetic usually favours RO strongly at Canadian fuel prices, and we will run it with your numbers rather than assert it.

The cooling tower side

Cooling towers concentrate whatever the makeup water brings, so the levers are the same: better makeup, smarter cycles, and side-stream filtration to strip the solids that the tower scrubs from the air. A side-stream filter on a recirculating loop keeps heat-exchange surfaces cleaner and reduces the biocide demand. Where makeup water is scarce or expensive, treated plant effluent can serve as tower makeup after polishing, a reuse route more Canadian plants adopt every year.

Sized from your water analysis

We supply RO skids, softeners, filtration packages, blowdown heat-recovery equipment and side-stream filters, and we size them from your water analysis and operating pressures. Send the analysis, the boiler and tower specifications and your current cycle count. The proposal will show the water, fuel and chemical savings line by line. Legionella management has also moved from good practice to expectation in Canadian facilities, and while control programs are chemical and operational, the filtration and makeup-quality improvements we supply reduce the nutrient and solids load that makes towers hospitable in the first place.